T-Rex of America Forum Index T-Rex of America
Forum for T-Rex Enthusiasts
 
Photo GalleryPhoto Gallery FAQFAQ   SearchSearch   MemberlistMemberlist   UsergroupsUsergroups   RegisterRegister 
 ProfileProfile   Log in to check your private messagesLog in to check your private messages   Log inLog in 

hockey puck instalation

 
Post new topic   Reply to topic    T-Rex of America Forum Index -> Technical
View previous topic :: View next topic  
Author Message
K3
Contributing Member


Joined: 04 Jun 2009
Posts: 48

PostPosted: Fri Jun 12, 2009 11:29 pm    Post subject: hockey puck instalation Reply with quote

For all of you that have done this any tips for this wonderfull upgade. I replaced a bearing tonight and cleaned up the hub to install the new dampners in the moring.
Any tricks other than the lube ?
Back to top
View user's profile Send private message
Geezer
Contributing Member


Joined: 04 Jun 2009
Posts: 67
Location: Milwaukee WI

PostPosted: Sat Jun 13, 2009 12:24 am    Post subject: Reply with quote

Heavy duty C-Clamps...........worked for me.

Geez
Back to top
View user's profile Send private message Send e-mail
twn454
Killers Dad


Joined: 03 Jun 2009
Posts: 133
Location: Fort Washington, Md

PostPosted: Sat Jun 13, 2009 7:28 am    Post subject: Reply with quote

On the hub assembly the three ears that insert between the dampers take those and grind the sharp edges off on the two outsides where they come in contact with the dampers, this will let them slide in between them much easier.
Back to top
View user's profile Send private message
K3
Contributing Member


Joined: 04 Jun 2009
Posts: 48

PostPosted: Sat Jun 13, 2009 11:30 am    Post subject: Reply with quote

twn454 wrote:
On the hub assembly the three ears that insert between the dampers take those and grind the sharp edges off on the two outsides where they come in contact with the dampers, this will let them slide in between them much easier.


Great minds think alike,i did that in the preperation stage last night, the
C clamps worked great as well.
Maybe camapana can upgrade the big hex nut to a wing nut so It is easier to replace the rear bearings.
Back to top
View user's profile Send private message
Display posts from previous:   
Post new topic   Reply to topic    T-Rex of America Forum Index -> Technical All times are GMT - 4 Hours
Page 1 of 1

 
Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum


Powered by phpBB © 2001, 2005 phpBB Group