View previous topic :: View next topic |
Author |
Message |
K3 Contributing Member
Joined: 04 Jun 2009 Posts: 48
|
Posted: Fri Jun 12, 2009 11:29 pm Post subject: hockey puck instalation |
|
|
For all of you that have done this any tips for this wonderfull upgade. I replaced a bearing tonight and cleaned up the hub to install the new dampners in the moring.
Any tricks other than the lube ? |
|
Back to top |
|
 |
Geezer Contributing Member

Joined: 04 Jun 2009 Posts: 67 Location: Milwaukee WI
|
Posted: Sat Jun 13, 2009 12:24 am Post subject: |
|
|
Heavy duty C-Clamps...........worked for me.
Geez |
|
Back to top |
|
 |
twn454 Killers Dad

Joined: 03 Jun 2009 Posts: 133 Location: Fort Washington, Md
|
Posted: Sat Jun 13, 2009 7:28 am Post subject: |
|
|
On the hub assembly the three ears that insert between the dampers take those and grind the sharp edges off on the two outsides where they come in contact with the dampers, this will let them slide in between them much easier. |
|
Back to top |
|
 |
K3 Contributing Member
Joined: 04 Jun 2009 Posts: 48
|
Posted: Sat Jun 13, 2009 11:30 am Post subject: |
|
|
twn454 wrote: | On the hub assembly the three ears that insert between the dampers take those and grind the sharp edges off on the two outsides where they come in contact with the dampers, this will let them slide in between them much easier. |
Great minds think alike,i did that in the preperation stage last night, the
C clamps worked great as well.
Maybe camapana can upgrade the big hex nut to a wing nut so It is easier to replace the rear bearings. |
|
Back to top |
|
 |
|